"One Perfect Part at a Time"

Taig Lathe Add

There are some clamping moves that are repeated many times while making a series of parts on the Taig Lathe. Taig uses hex head 10-32 screws to lock the carriage gib and also clamp the tailstock and sliding center bar. It becomes a chore after a while picking up the correct hex wrench and fitting it to the screw head to make adjustments.

I have seen many examples where micro-lathe owners make a set of SS ball handle 10-32 screws and bend them about 80 degrees to act like a L handle. They look fabulous but you have to get the bend in the correct position.

What I show here are some store bought adjustable 10-32 threaded handles. They do the same job as the homemade handles except the handle position is adjustable. That’s much better in my book. Not quite as pretty as the homemade but a little more functional.

I purchased these at McMaster-Carr, Part Numbers 6271K11, 6271K19 and 6271K65. Pick the size you want. I bought all three sizes. I used the 9/16 length on the carriage. This is not a through hole so it shouldn’t bottom against the body. It works fine as is but could be a bit shorter. (grind down)

NOTE: Log in is for admin and members only, not required to post comments.