Micro Machinist Association
I know there are a number of Taig Tool owners in the Dallas, “North Texas” area. I have been contacted by about a half dozen in the past few years. Some close to Dallas and all within what we would call the metro and suburb area.
I believe there is an existing hobby machinist group in the area and I assume the members are more into general machine shop work (as I am) and perhaps less involved with the small (Micro) machinery like Taig (or Sherline). I haven’t pursued more information or membership as my time until recently has been at a premium. But I do run a fair number of web sites.
So what I am wondering is if there is an interest by a few local folks for an online low profile member only (private) meeting room for micro machining? No travel involved. (Maybe later?) I am open to all suggestions, but I envision a local club type BBS group where members get to know and help each other. Not a wide open “my tool is bigger than yours” brag forum.
I believe many home machinists may not want to participate in a wide open public forum. However, a private group of like-minded local folks (an association) may be just what is desired. I have had a request many times on how to “join my club” when in fact I never had one. I don’t want to own one either. I don’t intend to be the “main voice”. Just provide a communication service if I can.
The design for this registered member site is wide open for discussion. My offer is to provide whatever online service the members’ desire. New members join by asking. It could be a simple Taig or Micro Tool owners list, a forum or an all member blog. I built the bones, visit POSTEX Forums. I can easily add a specific subject area.
If my thinking is too narrow or too presumptuous, let me know. It’s only an idea right now…
So North Texas or beyond, please comment to this idea. Use the reply or send me an email.
One Response to Micro Machinist Association